Double Scissor Lift with 3500 kg load capacity

VP 250217


  • Double scissor lift for on-ground installation with extremely low drive-over height
  • High level of operating comfort due to continuously adjustable support plate length, no subsequent pushing of the vehicle required
  • Support plates and pull-outs granule-coated for optimum protection against vehicle slippage
  • Double the safety due to two redundant cylinders on each side of the scissors
  • No compressed air required to operate the lifting platform
  • Full lifting power even from the bottommost lifting height range thanks to innovative cylinder lift-out support
  • Quiet setting in the lowest position due to lowering delay installed as standard
  • Soft start from the lowest position for gentle attachment to the vehicle
  • High level of lateral stability due to generously sized scissor arms
  • No mechanical connection between the scissors, so no trip edges
  • Simple EMERGENCY OFF function in the event of power failure
  • Varnished with high-quality powder coating:
    • gentian blue, RAL 5010 (support plates)
    • anthracite grey, RAL 7016 (scissors, ground frame, operation desk)
    • Base frame with dual-layer powdered varnish boosts corrosion-resistance
  • Fully automatic synchronisation of support plates and high level of safety due to cylinder distance measurement system (“linear absolute measurement system”)
  • Crushing / shearing protection due to CE stop
  • Optionally long drive-over ramps for lowered vehicles

Standard Delivery:

  • Double scissor lift, type: TWIN F IV 3.5 A
  • 2 drive-over wedges
  • Operation desk, upright, with controller and hydraulic unit
  • Lockable main switch
  • Hydraulic hoses for 2 m distance between platform and unit
  • Cover plates for hydraulic hoses
  • Operating manual and test log
  • EC CE conformity instructions
  • Transport packaging
Brochure DE | EN | ES | FR
Technical datasheet EN | ES | FR
Technical data
Load capacity CE 3500 kg
Lifting height max. 1920 mm
Raising / Lowering time (load-dependent) approx. 35 s / 35 s
Drive-over height 105 mm
Support plate width max. 605 mm
Support plate length 1550 mm - 2100 mm
Total width, recommended 1955 mm
Pinch point protection audible warning signal
Operating pressure 270 bar
Motor power hydraulic unit 2.2 kW
Fuse gG 16 A
Power supply 3/N/PE 400 V 50 Hz
Dimensions packaging (L x W x H) 2100 mm x 760 mm x 710 mm
Weight incl. packaging 900 kg
Hydraulic fluid quantity (not included in standard delivery) 9 l